BENDIXKING
Aerocruze 100 - Mooney Digital Autopilot Package
Part No:
Currently a 6-8 Month Factory Lead TimeDESCRIPTION
Mooney Autopilot Package By BendixKing
The AeroCruze 100 is an affordable and flexible digital autopilot system for M20B, M20C, M20D, M20E, M20F, M20G, M20J, M20K, M20L, M20M, M20R, M20S, M20TN, M20U, and M20V. The AeroCruze100 provides seamless integration with the AeroVue Touch EFIS as well as a variety of other manufacturers.
Aerocruze 100 Digital Autopilot System Features
When connected to a panel-mounted GPS, autopilot follows roll steering commands to fly complex flight plans Similar to lane assist in automobiles, the AEP stand-by mode monitors aircraft bank angle. Autopilot corrects the bank angles greater than 45 degrees by automatic roll command.
Emergency Autopilot Level
An emergency autopilot level button helps to bring the aircraft to a wings-level position. Connects to either hand-held GPS or IFR panel mount GPS systems. When connected to hand-held GPS, follows programmed flight plans.
Mooney Autopilot Size Variations
The complete system is offered at a low cost, with the choice of two form-factor variations: 3" round and flat pack.
STC Pending:
- Mooney M20B
- Mooney M20C
- Mooney M20D
- Mooney M20E
- Mooney M20F
- Mooney M20G
- Mooney M20J
- Mooney M20C
- Mooney M20D
- Mooney M20E
- Mooney M20F
- Mooney M20G
- Mooney M20J
- Mooney M20K
- Mooney M20L
- Mooney M20M
- Mooney M20R
- Mooney M20S
- Mooney M20TN
- Mooney M20U
- Mooney M20V
Mooney Autopilot Sales and Installation
Speak with an expert toll-free at 800-474-9714 for recommendations on your aircraft today for digital autopilot system requirements for Mooney aircraft!
Features
- Bank Angle Select (if no GPS signal)
- Track Select
- GPS Nav (point to point type flight plans)
- GPSS (roll steering commands)
- Vertical Speed Select
- Altitude Hold
- Altitude Select
- Altitude Pre-Select
- GPSV (LPV Approaches)
- Control Wheel Steering
- Emergency Level
- AEP (Bank Angle Protection Mode)
- Roll Servo
- Pitch Servo
- Install Kit
- Wiring Harness
Specifications
- 12-28 Volt Variants
- 2” Round: 2.5” H x 2.5” W x 5.5” D
- 3” Round: 3.25” H x 3.25” W x 5.5” D
- Flat Pack: 1.6” H x 4.3” W x 6.1” D